Craftsman 919.19541 owner manual Before Each Start-Up, How to Start

6.After 20 minutes, close the drain valve (clockwise). The air receiver will fill to “cut-out” pressure and the motor will stop.

The compressor is now ready for use.

Before Each Start-Up:

1.Place On/Auto/Off lever to “OFF”.

2.Pull regulator knob out, turn counterclockwise until it stops. Push knob in to lock in place.

3.Attach hose and accessories. NOTE: The hose or accessory will require a quick connect plug if the air outlet is equipped with a quick connect.

Too much air pres- sure causes a haz- ardous risk of bursting. Check the

manufacturer’s maximum pressure rating for air tools and accessories. The regulator outlet pressure must never exceed the maximum pres- sure rating.

How to Start:

1.Turn the On/Auto/Off lever to “AUTO” and allow tank pressure to build. Motor will stop when tank pressure reaches “cut-out” pressure.

2.Pull the regulator knob out and turn clockwise to increase pres- sure. When the desired pressure is reached push knob in to lock in place. The compressor is ready for use.

NOTE: Always operate the air com- pressor in well-ventilated areas free of gasoline or other combustible vapors. If the compressor is being used to operate a sprayer DO NOT place near the spray area.

D24910 16- ENG