Cooling System (not shown): This compressor contains an advanced design cooling system. At the heart of this cooling system is an engi- neered fan. It is perfectly normal for this fan to blow air through the vent holes in large amounts. You know that the cooling system is working when air is being expelled.

Air Compressor Pump (not shown):

Compresses air into the air tank. Working air is not available until the compressor has raised the air tank pressure above that required at the air outlet.

Check Valve: When the air compres- sor is operating, the check valve is “open”, allowing compressed air to enter the air tank. When the air com- pressor reaches “cut-out” pressure, the check valve “closes”, allowing air pressure to remain inside the air tank.

Pressure Release Valve: The pres- sure release valve, located on the side of the pressure switch, is designed to automatically release compressed air from the compressor head and the outlet tube when the air compressor reaches “cut-out” pres- sure or is shut off. The pressure release valve allows the motor to restart freely. When the motor stops running, air will be heard escaping from this valve for a few seconds.

Pressure

Release

Valve

Check Valve

No air should be heard leaking when the motor is running or after unit reaches “cut-out” pressure.

Air Intake Filter (not shown) This filter is designed to clean air coming into the pump. This filter must always be clean and ventilation openings free from obstructions. See "Maintenance".

How to Use Your Unit

How to Stop:

1.Set the On/Auto/Off lever to “OFF”.

Before First Start-up

Serious damage may result if the

following break-in instructions are not closely followed.

This procedure is required before the air compressor is put into service and when the check valve or a complete compressor pump has been replaced.

Break-in Instructions

1.Make sure the On/Auto/Off lever is in the "OFF" position.

NOTE: If quick connect is installed, pull coupler back until it clicks to pre- vent air from escaping through the quick connect.

2.Plug the power cord into the cor- rect branch circuit receptacle. (Refer to Voltage and Circuit Protection paragraph in the Installation section of this manu- al.)

3.Open the drain valve fully (coun- terclockwise) to permit air to escape and prevent air pressure build-up in the air tank during the break-in period.

4.Move the On/Auto/Off lever to "ON/AUTO" position. The com- pressor will start.

5.Run the compressor for 20 min- utes. Make sure the drain valve is open and there is minimal air pressure build-up in tank.

15- ENG

D24910

Page 15
Image 15
Craftsman 919.19541 owner manual How to Use Your Unit How to Stop, Before First Start-up, Break-in Instructions