Craftsman 973.2748.70 owner manual Charging Your DRILL-DRIVER, To Charge

_1= WARNING: Always wear safety goggles or safety glasses with side shields when operating tools. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury.

_k WARNING: Do not allow familiarity with your ddll-ddver to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury.

CHARGING YOUR DRILL-DRIVER

The battery pack for this tool has been shipped in a low charge condition to prevent possible problems. Therefore, you should charge it until light on front of charger changes from red to green.

Note: Battedes will not reach full cha_ge the first time they are charged. Allow several cycles (drilling followed by recharging) for them to become fully charged.

TO CHARGE

•Charge battery pack only with the charger provided.

•Make sure power supply is normal house voltage, 120 volts, 60 Hz, AC only.

•Connect charger to power supply.

•Place battery pack in charger aligning raised rib in charger with groove in battery pack.

•Press down on battery pack to be sure contacts on

battery pack engage properly with charger contacts.

•Normally, the yellow and green lights on charger

.will come on. This indicates charger is in soft stad mode and should switch to fast charge mode within 5 minutes. When charger is in fast charge mode the red light will come on. If after a period of 15 minutes the yellow and green lights remain on, remove battery pack, wait I minute and reinsert

	battery pack in charger. If the yellow and green	H
	lights continue to remain on after an additional 15
	minutes, the battery pack is damaged and will not
	accept a charge. Return battery pack to your
	nearest Sears Repair Center for checking or
	replacing.
•	When your battery pack becomes fully charged, the
	red light will turn OFF and the green light will turn
	ON.
•	After normal usage, 1 hour of charging time is
	required to be fully charged. A minimum charge
	time of 1-1/2 hours is required to recharge a
	completely discharged tool.
•	The battery pack will become slightly warm to the
	touch while charging. This is normal and does not
	indicate a problem.
•	Do not place charger in an area of extreme heat or
	cold. It will work best at normal room temperature.

,_ CAUTION: Your drill-driver'sbattery pack contains special high temperature batteries to

help prevent battery damage when left on charge for extended periods of time. However, once the batteries become fully charged, we recommend that you unplug your charger from power supply and remove the battery pack.

7