7.Place assembled gun and wand on pressure washer holder.
8.Place pull cord into the wire bracket holder.Pull the cord under the wire bracket to the right of the wire loop. Lift the pull cord handle up and slide the cord to the left, sliding the cord into the wire loop. Next slide handle behind the wire bracket to the left of the wire loop. Engine recoil will pull the cord into its final position.
Checklist
Before going any further please review the following:
•Be sure you have completed assembly instructions.
•Double check all fittings to be sure they are tight.
IMPORTANT: Before any attempt to start your pres- sure washer be sure to check engine oil (See Opera- tion under Engine Oil.)
OPERATION
Know Your High Pressure Washer
Read this Owner’s Manual and Safety Rules before operation of your High Pressure Washer Compare this illustration with our pressure washer to familiarize yourself with the location of various con- trols and adjustments. Save this manual for future reference.
PUMP- Develops high pressure.
SPRAY GUN
ASSEMBLY 
HIGH PRESSURE
HOSE
GAS TANK/CAP
HANDLE
RECOIL
STARTER
PRESSURE REGULATOR- Allows you to adjust the pressure of the outlet stream.
CHOKE
OIL FILL
ENGINE RUN/STOP SWITCH- Sets engine in starting mode for recoil starter — Stops running engine.
RECOIL STARTER- Used for starting the engine | ENGINE |
|
manually. | STOP/START |
SPRAY GUN ASSEMBLY (Contains Gun and Wand)- Controls the application of water onto cleaning surface with trigger device.
OIL FILL- Port where engine oil is poured. |
|
GAS TANK/CAP- Cap is removed and unleaded | PRESSURE |
gasoline is poured. | REGULATOR |
CHEMICAL INJECTION TUBE AND FILTER- Mixes water and detergent in outlet water flow.
HIGH PRESSURE OUTLET- Connection for high pres- sure hose.
PUMP
CHOKE- Lever used for starting unit.
HIGH
WATER INLET
PRESSURE
OUTLET
CHEMICAL
INJECTOR
TUBE & FILTER
CONNECTION
7
