Creative 525D Getting Up and Running

6
Section 2
Getting Up and Running
 Loading the Battery
Before using the camera, user must load
NP60 rechargeable Li-ion battery.
1. Follow the arrow direction and slide to
eject the battery / SD cover.
2. Insert the batteries according to the
correct polarity marks (+ or -)
3. Close the battery/SD Card Cover firmly.
 Charging Battery
Please fully charge Li-ion Battery via power adaptor for at least ten h ours before you use the
camera for the first time.
(1) Plug power adaptor cable into the USB port.
(2) W hen charging battery, the self-timer LED light keeps blinking. LED light will stay on after
battery charge completes.
(3) It takes three hours to fully recharge the battery each time.
 Inserting and Removing an SD Card（Optional）
The camera comes with 32MB built-in memory that allows you to stor e pictures, movies,
recorded voice and music. You can expand the memory capacity by using an o ptional SD or
MMC memory card up to 2G. To insert a memory card, refer to the figure above and:
1. Open the battery/SD card cover.
2. Insert the memory card until it locks into position.
To remove an installed SD card, press the card inwards to release it. W hen the card pops
out, gently remove it from its slot.
Note
When a memory card is fitted, movies and pictures are
saved on card rather than on the built-in memory.
Batter
y
SD Card