Creative Dxr2 Computer, Drive in Your, Step 3: Install the

Step 3: Install theDrive in YourComputer

You may want to connect the cables as described below before you insert the drive into the bay. Then, feed the cables through the bay as you insert the drive.

Set the Master/Slave jumpers to Master as shown in the figure on page 2, unless you know that you will be connecting to the Primary IDE connector with the hard disk drive.

1.Insert the PC-DVD drive into the drive bay as shown.

2.Connect a PC power cable to the PC-DVD drive. The computer’s power supply is usually located in a rear corner; several power cables extend from the box with connectors available for internal devices.

Power In connector

Power cable

Installing PC-DVD Encore 7