Creda E530E/R530E manual Something Wrong?, Problem Check

Something Wrong?

Before calling a Service Engineer, please check through the following lists.
	THERE MAY BE NOTHING WRONG.
Problem	Check
Slight odour or small amount	This is normal and should cease after a short period.
of smoke when grill / oven
used first time
Nothing works.	If you find that the timer display is blank, then it is likely that there is no electricity
	supply to your oven. Check:
	(i) That the main cooker wall is switched on
	(ii) Other appliances, to see if you have had a power cut
	(iii) The main circuit breaker for the property
Display shows 0.00 AUTO.	The power supply to your oven has possibly been interrupted, but has now come
	back on again. Reset the timer to the correct time of day and “Manual” operation
	using instructions given in the timer section of the book.
Main Oven does not work, but	Your timer may be set for an Auto Cooking programme:
the Grill and Top Oven work.	Check the timer to see whether "Auto" is lit or flashing. If it is then please follow the
	instructions given in the Timer section of this book to return the timer to Manual
	operation.
Top Oven and Grill do not	Operating the cooker under the following conditions may cause a safety device to
work, but the Main Oven	operate:
works.	(a) Grilling with the door closed - Always grill with the door fully open
	(b) Grilling for an excessively long period at maximum setting - see Grilling guide.
	Switch off appliance and allow to cool for approx 30 mins. Switch the cooker back on
	and check that the Grill / Top oven is now operating.
Grill does not work.	Check that you have selected:- “Grill” function on the “Top Oven / Grill Select” knob (B)
	and a Grill setting on the “Grill” knob (A) - see grilling page.
Grill keeps turning on and off.	When the Grill control is operating at less than its maximum setting, the Grill will cycle
	on and off, this is normal and not a fault.
Can not set an “Auto Cook”	Remember: "Cook Period" is the actual length of time for which, the timer will switch
programme	the main oven on as part of an "Auto Cooking" programme.
Draught from beneath control	A gentle flow of air will be blown from beneath the control panel when the appliance
panel.	is used. If the appliance is still warm, this cooling fan may run on, or restart itself after
	all of the controls have been turned off.
	The fan will stop once the appliance has been cooled. This is normal and not a fault.
Timer buzzer/bleeper	Buzzer/Bleeper should stop automatically after 2 minutes. If not, press minute minder
operates continually	button to silence.
Grilling is uneven	Ensure that Grill pan has been positioned as stated in the Grilling section of this book.
Oven does not cook evenly	Check: (a) Temperature and shelf positions are as recommended in the Oven
	Temperature Charts.
	(b) Oven utensils being used allow sufficient air flow around them.
Oven temperatures too	Check temperature and shelf positions are as recommended in the Oven Temperature
high or low	Charts.
	It may be necessary to increase or decrease the recommended temperature slightly to
	suit your taste.
Oven lamp does not work	The oven lamp is not covered by the guarantee.
	The part is easily changed (see the section on oven lamp replacement). A new lamp
	may be obtained from our Parts department (see Back Cover).
Condensation on the wall at	Steam and / or condensation may appear from the vent at the rear of the appliance
the rear of the cooker.	when using an oven particularly for foods with a high water content e.g. frozen chips,
	roast chicken etc. This is normal, and any excess should be wiped off.
Steam / Condensation in the	Steam is a by - product of cooking any food with a high water contact.
oven after use.	To help minimise always:
	a) Try to avoid leaving food in the oven to cool after being cooked.
	b) Use a covered container, wherever possible.

If you have been through the above list and there is still a problem, contact your nearest Service Office

(see back cover).

39