[ Section 5- Troubleshooting ] | [ Page 19 ] |
SERVICE & TROUBLESHOOTING
Setting or Resetting Time and Date
| SET UP PROCEDURE |
SWITCH | FUNCTION IN SPECIAL SWITCH MODE |
I/O | ON/OFF SWITCH |
1When held in, displays the code for current parameter
2Step back to previous parameter, and while held in displays the parameter code. When released, displays the value of the parameter.
3Advance to the next parameter. (same as above)
Increase the value of the current parameter.
XDecrease the value of the current parameter
To set the parameters complete the following steps:
1.This can only be entered from the panel OFF mode.
2.Press and HOLD IN any key EXCEPT the ON/OFF key for three seconds.
3.While Holding key, press and release the ON/OFF key.
You will now be in the programming mode.
CODE | PARAMETER | SET AT: | |
bss | Blast Soft Stat | 33 |
|
bhs | Blast Hard Stat | 12 |
|
bfs | Blast Freeze Stat |
| |
sss | Store Soft Stat | 33 |
|
shs | Store Hard Stat | 33 |
|
sfs | Store Freeze Stat |
| |
bsd | Blast Soft Differential | 35 |
|
bhd | Blast Hard Differential | 35 |
|
bfd | Blast Freeze Differtial | 35 |
|
ssd | Store Soft Differential | 35 |
|
sfd | Store Freeze Differential | 35 |
|
|
|
|
|
bd1 | Blast Duration 1 (normally 30 min.) | 30 |
|
bd2 | Blast Duration 2 (normally 60 min.) | 60 |
|
bd3 | Blast Duration 3 (normally 90 min.) | 90 |
|
bd4 | Blast Duration 4 (normally 240 min) | 240 |
|
cab | Cabinet Number | 1 |
|
ala | Alarm Duration | 900 (15 min) | |
ddc | Defrost Duration for Cabinet | Hex. Switch | |
dic | Defrost Interval for Cabinet | Hex. Switch | |
ddp | N/A defrost Duration for PoD minutes, Set Manually |
|
|
dip | N/A defrost Interval Hours, Set Manually |
|
|
det | Defrost Target Temperature | 39 |
|
|
|
|
|
yr | Calander Year Setting | Set Accordingly |
|
nth | Calander Month Setting | Set Accordingly |
|
day | Calander Day Setting | Set Accordingly |
|
hr | Calander Hour Setting | Set Accordingly |
|
ute | Calander Minute Setting | Set Accordingly |
|
