5925 Heisley Road • Mentor, OH
Retherm | ||
Ovens | ||
| ||
Rev. 2 (6/08) | Page 5 of 11 | |
|
|
OPERATING INSTRUCTIONS (continued)
HOW TO OPERATE WITH FOOD:
Manual (Timed mode) Operation
See “HOW TO SET CONTROL” for programming instructions
1.Push the power switch to “ON”.
2.Press the SELECT button and choose the TIMED mode.
3.Press the COOK button and set to desired temperature
4.Press the PROBE/TIME button and set the desired time.
5.Press the HOLD button and set the desired temperature.
6.Place the food into oven. Close door and double check cooking time and temperatures. Then press the START button to start the cooking/retherm cycle and the Cook LED will light up.
7.The oven will beep and automatically switch the HOLD mode at the end of the cooking cycle. The Cook LED will go out and Hold LED will light up.
PROBE COOKING
See “HOW TO SET CONTROL” for programming instructions
1.Push the power switch to “ON”.
2.Press the SELECT button and choose the Probe mode.
3.Insert the probe jack into the receptacle located inside the oven top, near the fans. The probe temperature display will show the digital temperature of the probe.
4.Put sanitized probe into center of food product. Make sure food is in the center of the pan, in the center of the oven.
5.Press the start button. The Cook LED will light up and the display will show the internal temperature of the food being cooked.
NOTE: Do NOT change the mode of controls (probed or timed) while oven is operating in a Cook/Retherm cycle. Oven must be off, or in the HOLD cycle, to change the
timer or probe operation.
HOW TO SET HOLD ONLY MODE:
NOTE: Cold food is NOT to be added when unit is operating in the HOLD mode.
For HOLD mode, preheat unit to 180°F/82°C for 60 minutes.
1.Push the power switch to “ON”.
2.Press the HOLD button and set the desired hold temperature.
3.Press the PROBE/TIME button to set it to zero time.
4.Press the START button and the Hold LED will light up.
HOW TO SHUT DOWN OVEN:
Push power switch to “OFF”.
CAUTION: Ventilating fans will continue to run until cabinet is cool. Do NOT disconnect the power supply to the cabinet while the ventilating fans are still operating, or damage to components could result.
Call
