Crown Audio CL Series, CH Series Models CL1 & CL2 Stereo, Models CL1 & CL2 Bridge Mode

CH and CL Series Power Amplifiers

2 Setup

2.7.5. Models CL1 & CL2 Stereo

Mode

See Figure 2.14. In this example, Channel 1 and

Channel 2 are wired to 4/8-ohm speaker loads.

Make sure the Mode switch is set to the “Stereo” position.

INPUTS: Connect input wiring for each channel.

OUTPUTS:

•Connect Channel 1 positive (+) speaker lead to Channel 1 positive (+) terminal of amp.

•Connect Channel 1 negative (–) speaker lead to Channel 1 negative (–) output terminal of amp.

•Repeat similarly for Channel 2.

Refer to Section 2.5 for output connector pin assignments.

2.7.6Models CL1 & CL2 Bridge Mode

See Figure 2.15. In this example, a 4/8-ohm load is connected in Bridge Mono across the positive terminals of Channel 1 and Channel 2. Make sure the Mode switch is set to the “Bridge” posi- tion.

NOTE: When operating in Bridge-Mono mode, turn down (full CCW) the level control for Channel 2, as the Channel-1 level control works both channels.

INPUTS: Connect input wiring to Channel 1.

OUTPUTS: Connect positive (+) speaker lead to Channel 1 positive (+) terminal of amp. Connect negative (–) speaker lead to Channel 2 positive

(+)terminal of amp. Do not connect to negative output terminals.

Refer to Section 2.5 for output connector pin assignments.

Mixer

Figure 2.14 Models CL1 & CL2 Wiring for Stereo Mode

(Shown with No-Touch Cover Removed)

Mixer

Figure 2.15 Models CL1 & CL2 Wiring for Bridge Mode

(Shown with No-Touch Cover Removed)

Operation Manual page 11