Cub Cadet GT 3200 warranty D. Parking Brake Lever, H. Forward Pedal, E. PTO Switch, F. Brake Pedal

Models: GT 3200

1 44
Download 44 pages 50.08 Kb
Page 13
Image 13
D. Parking Brake Lever

D. Parking Brake Lever

H. Forward Pedal

Figure 4

The parking brake lever is located to the right of the steering wheel in the dash panel. With the brake pedal depressed fully, push the parking brake lever downward and release the brake pedal to lock the parking brake.

E. PTO Switch

The PTO switch is located on the lower/right side the dash panel. Pull the knob outward to engage the PTO clutch. Push the knob inward to disengage the PTO clutch.

F. Brake Pedal

Figure 5

The brake pedal is located at the front of the right running board above the forward and reverse pedals. Depress to stop the tractor and disengage the cruise control. Fully depress the brake pedal to activate the safety interlock switch when starting the tractor.

G. Reverse Pedal

Figure 6

WARNING: Always look down and behind before and while backing. Do not oper- ate the tractor when children or others are around. Stop the tractor immediately if someone enters the area.

The reverse control pedal is located below the brake pedal. Depress the pedal to move in reverse.

Figure 7

The forward control pedal is located on the right running board below the brake pedal. Slowly press down on the pedal to start moving forward. The forward ground speed of the tractor is directly affected by the distance the pedal is depressed.

I.12V Power Outlet

The 12V power outlet is located on the front/right surface of the fender, below the seat. It is used for the convenience of plugging in accessories that require a power source with a maximum load of 5 amps at 12 volts.

J. Seat Adjustment Lever

The seat adjustment lever is located below the seat. This lever is used to adjust the seat forward or backward.

K. Transmission Release Rod

The transmission release rod is located at the back of the tractor in the draw bar. This rod, when engaged, allows the tractor to be pushed short distances by hand.

To disengage the transmission, pull back on the rod until its locking flange is visible outside the drawbar, then lower the rod into the slot and release. To reengage the transmission, pull back on the rod, lift out of the slot and release.

L.Transmission Oil Fill/Dipstick The transmission oil fill/dipstick is located at the back of the tractor in the rear draw bar. The handle of the transmission oil dipstick serves as the fill tube plug and should fit snugly in the fill tube.

13

Page 13
Image 13
Cub Cadet GT 3200 warranty D. Parking Brake Lever, H. Forward Pedal, E. PTO Switch, F. Brake Pedal, G. Reverse Pedal