Headlight Bulb Replacement | Adding Transmission Oil |
Replace headlight bulbs as follows: (See Figure 17)
1.After noting which wire connects to each terminal, unplug the wire harness leads from the headlight socket terminals.
2.Rotate the socket assembly as follows to remove from the reflector housing:
Socket Tab
Terminals
Socket
Reflector Housing
Reflector Notch
Figure 17
WARNING: The fluid for your transmission has been spe- cially formulated to ensure the safe and proper opera- tion of your tractor. Add Cub Cadet Drive System Fluid Plus ONLY. Do not use any other fluid.
WARNING: Never overfill the transmission case. Damage may result if the oil level in the transmission case is below the “ADD” mark or over the “FULL” mark of the dipstick.
For best results, fill to the “FULL” mark on the dipstick as opposed to adding a given quantity of oil. Always check the level on the dipstick before adding more oil. Refer to Figure 15.
Refer to the Lubrication Illustration for information regarding the proper type of oil to add to the transmission case. See the Specifications Chart for the quantity required.
• Left headlight — approximately 1/ | • Place the tractor on a level surface | |
and engage the parking brake. Stop | ||
4 turn counterclockwise. | ||
the engine and remove the ignition | ||
• Right headlight — approximately | ||
key. | ||
1/4 turn clockwise. | ||
|
3.Push the bulb inward and turn • Clean the area around the Transmission Oil Fill /Dipstick to
counterclockwise to remove from
the socket.prevent debris from entering the transmission case.
4.Align the post of the bulb base
| with the notch in the socket, then | • | Remove the dipstick from the oil fill | |||||||
|
| tube and SLOWLY pour oil into the | ||||||||
| push | the | bulb | inward and | turn |
| ||||
|
| oil fill tube. Fill the transmission | ||||||||
| clockwise to lock |
|
|
|
|
| ||||
|
|
|
|
|
| case until the oil level reaches the | ||||
5. | With | the | terminals | pointing |
| |||||
| “FULL” mark on the dipstick. | |||||||||
| upward, | align | the | tab | of | the |
| |||
| • Reinstall the dipstick securely into | |||||||||
| socket with | the notch | of | the | ||||||
|
| the oil fill tube. | ||||||||
| reflector. Push the socket inward |
| ||||||||
|
|
| ||||||||
| and turn as follows to lock: |
|
| WARNING: The oil fill plug/ | ||||||
• Left |
| dipstick must be installed | ||||||||
• | Right | turn | counter- |
| securely into the fill tube at | |||||
| all times when the engine is | |||||||||
| clockwise. |
|
|
|
|
|
| |||
|
|
|
|
|
|
| operating. | |||
|
|
|
|
|
|
|
|
|
|
6.Connect the wire harness leads to the appropriate socket terminals.
26