SECTION 6: ADJUSTMENTS and MAINTENANCE
Seat Adjustment
WARNING: Do not adjust the seat when the tractor is moving, as this could cause the operator to lose control of the tractor.
For the comfort of the operator, the tractor is equipped with an easy to operate adjustable seat. There are also three seat mounting positions to provide additional adjustment.
To adjust the seat forward or back, slide the seat adjustment lever to the left; reposition the seat to your most comfortable position; and release the seat adjustment lever. See Figure 12.
Seat
Adjustment
Lever
Figure 12
If additional adjustment is desired, flip the seat forward, remove the four screws fastening the seat, and re- mount the seat on the hinge brackets as follows (See Figure 13):
Seat
Rearward
Seat Hinge |
|
| Seat |
Bracket |
| Forward | |
Figure 13 |
| ||
•Seat
•Seat
•Seat
Brake Inspection and Adjustment
During normal operation, the tractor brake is subject to minimal wear. How- ever, the brake should be periodically tested, and adjusted if necessary.
Checking the Brake.
Place the tractor on a firm and level surface. Stop the engine and remove the ignition key.
Pull and lock the transmission release rod in the “Transmission Released” position. Perform the following checks: NOTE: The tractor may be difficult to push because of the hydro transmis- sion’s braking action.
•Engage the parking brake. If the tractor can be pushed forward or rearward, the braking force must be increased.
•Release the Parking Brake Lever. If the tractor cannot be pushed forward or rearward, the braking force must be decreased.
Turning Radius Adjustment
This tractor is equipped with hydraulic power steering which is set at the factory. The turning radius should be equal for both left and right hand turns. If adjustment is necessary please contact your authorized Cub Cadet dealer.
Accessing Engine Compartment
The engine compartment can be accessed by raising the hood as follows:
•Lift the hood straight upward at the recessed notches of the side panels to disengage the internal hood latch.
•Carefully pivot the hood forward to open.
To close the hood:
•Carefully pivot the hood rearward to lower.
•Push down on the front of the hood to engage the internal hood latch.
20
