CYRAQ™ 21 | CyberResearch® Displays |
2.6 Connecting the Display
IMPORTANT! Before connecting the power cable to the display, connect all the other cables first.
Figure 16: CYRAQ Connection Layout
Power |
| Power |
| DVI Video |
| Analog |
| USB Port |
| Serial Port |
Switch |
|
|
| Port |
| Video Port |
|
|
|
|
|
|
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
3NOTE: Turn off the computer before connecting the display
1.After connecting all other cables, connect the power cable to the power jack on the back of the display; refer to Figure 16.
2.Flip the Power Switch on the rear of the display (Figure 16) to the “On” position.
3. Press the On/Off Button |
| on the front of the display, the status light will |
| ||
| ||
illuminate. |
|
|
4.Start the computer.
5.If the computer is running, restart.
6.The display should now function normally.
3NOTE: See section 4 Touchscreen for connection and driver instruction
3NOTE: If the CYRAQ’s screen remains blank or displays the error message “Out of Range” or “No Input Signal,” there may be a connection or signal problem. One or a combination of the possibilities listed below may be the cause:
¾Windows resolution is set either too high or two low for the display; check the resolution by reinstalling the old monitor
¾The refresh rate may be set too high. The refresh rate of an LCD monitor doesn’t need to be set as high as a CRTs refresh rate; set the refresh rate @ 60Hz.
22 | ©Copyright 2005 CyberResearch, Inc |