Cyclades PC400 installation manual Software Installation

sh install

NOTE: at this point you should read the file README included in the directory pc400-<version>to learn about any changes implemented since this manual was produced.

(to run the install script)

This script will detect the system information (kernel version, current Cyclades-PC400 driver version, etc.) and install the proper driver package files. A default configuration file will be placed in /etc/cyclades/pc400/ pc400.cfg and is used when /usr/local/sbin/pc400util -p is executed.The following utilities are compiled and installed :

/usr/local/sbin/pc400util

/usr/local/sbin/pc400load

/usr/local/sbin/pc400dump

/usr/local/sbin/pc400hwtest

/usr/local/sbin/pc400syslog

And the firmware is installed in /usr/local/lib/pc400.bin

If an older version of the PC400 driver already exists, the files pc400.c and pc400.h are backed up with modified names in the same directory. If a newer version is already installed, the files will not be updated with those of the older driver.

Configure the kernel by executing “make config” or “ make menuconfig”:

Please note the following before beginning the kernel configuration. The only difference between selecting ‘Y’ , ∗‘’ or ‘M’ is the following: ‘Y’ or∗’‘causes the driver to be compiled as part of the kernel and is activated every time the computer is booted; ‘M’ creates the driver as a module, which can be loaded or unloaded with a command without the need to reboot the computer.

Chapter 3 Software Installation 10