Cyclone MKV 2 Multimedia Adapter
Page 40 .
Version 0.9
To use the copy function of your media player, the device, or partition, that
you want to copy the data onto must be formatted with one of the following file
systems: FAT, FAT32, NTFS or ext3.
Please use only targets formatted w ith FAT, FAT32, NTFS or ext3 for copying
onto. Otherwise you will receive an error message.
The
The
The
The player
player
player
player no
no
no
no longer
longer
longer
longer responds:
responds:
responds:
responds:
If the Cyclone MKV 2 no longer responds to the remote control, the batteries
may be dead. Please replace them with new ones.
Obstruction of the infrared ’ s field of vision may also cause unresponsiveness
in the player. Please remove all potential obstructions between the player
and remote control
Please clean th e infrared receiver.
No
No
No
No audio
audio
audio
audio output:
output:
output:
output:
Please check that the volume for your TV, home entertainment system and
Cyclone has not been set too low. Also ch eck that the sound has not been
switch off via the mute button.
The audio digital output may also be incorrectly configured.
If you have connected the media player via HDMI cable, please en sure that
HDMI RAW, LPCM Dual Channel or LPCM Multi-Channel output is selected.
If you have connected the media player via optical cable, please ensure that
SPDIF RAW or LCMP Dual Channel output is selected.
The
The
The
The player
player
player
player has
has
has
has failed
failed
failed
failed during
during
during
during Firmware
Firmware
Firmware
Firmware upgrade:
upgrade:
upgrade:
upgrade:
To recover the Cyclone MKV 2 from a firmware upgrade failure, power off the
player and disconnect the power cable.
Insert a USB pen drive containing the firmware. Please note that only the
firmware update files should be on the pen drive.
Connect the power cable back into the Cyclone MKV 2 and switch it on. This
should cause the player to attempt to reinstall the software.