CY62167EV18 MoBL®
Document #: 38-05447 Rev. *G Page 5 of 13
Switching Characteristics
Over the Operating Range[13, 14]
Parameter Description 55 ns Unit
Min Max
Read Cycle
tRC Read Cycle Time 55 ns
tAA Address to Data Valid 55 ns
tOHA Data Hold from Address Change 10 ns
tACE CE1 LOW and CE2 HIGH to Data Valid 55 ns
tDOE OE LOW to Data Valid 25 ns
tLZOE OE LOW to Low-Z[15] 5ns
tHZOE OE HIGH to High-Z[15, 16] 18 ns
tLZCE CE1 LOW and CE2 HIGH to Low-Z[15] 10 ns
tHZCE CE1 HIGH and CE2 LOW to High-Z[15, 16] 18 ns
tPU CE1 LOW and CE2 HIGH to Power Up 0 ns
tPD CE1 HIGH and CE2 LOW to Power Down 55 ns
tDBE BLE/BHE LOW to Data Valid 55 ns
tLZBE BLE/BHE LOW to Low-Z[15] 10 ns
tHZBE BLE/BHE HIGH to High-Z[15, 16] 18 ns
Write Cycle[17]
tWC Write Cycle Time 55 ns
tSCE CE1 LOW and CE2 HIGH to Write End 40 ns
tAW Address Setup to Write End 40 ns
tHA Address Hold from Write End 0 ns
tSA Address Setup to Write Start 0 ns
tPWE WE Pulse Width 40 ns
tBW BLE/BHE LOW to Write End 40 ns
tSD Data Setup to Write End 25 ns
tHD Data Hold from Write End 0 ns
tHZWE WE LOW to High-Z[15, 16] 20 ns
tLZWE WE HIGH to Low-Z[15] 10 ns
Notes
13.Test conditions for all parameters other than tri-state parameters are based on signal transition time of 1V/ns, timing reference levels of VCC(typ)/2, input pulse levels
of 0 to VCC(typ), and output loading of the specified IOL/IOH as shown in AC Test Loads and Waveforms on page 4.
14.AC timing parameters are subject to byte enable signals (BHE or BLE) not switching when chip is disabled. See application note AN13842 for further clarification.
15.At any given temperature and voltage condition, tHZCE is less than tLZCE, tHZBE is less than tLZBE, tHZOE is less than tLZOE, and tHZWE is less than tLZWE for any given
device.
16.tHZOE, tHZCE, tHZBE, and tHZWE transitions are measured when the output enters a high impedance state.
17.The internal memory write time is defined by the overlap of WE, CE1 = VIL, BHE and/or BLE = VIL, and CE2 = VIH. All signals must be ACTIVE to initiate a write and
any of these signals can terminate a write by going INACTIVE. The data input setup and hold timing must be referenced to the edge of the signal that terminates the write.
[+] Feedback