D-Link AG DI-784 manual Advanced Performance 802.11g RTS Threshold, Dtim interval

Using the Configuration Menu (continued)

Advanced > Performance > 802.11g (Continued)

RTS Threshold-	This value should remain at its default setting of 2346. If incon-
	sistent data flow is a problem, only a minor modification should
	be made.
Fragmentation-	This value should also remain at its default setting of 2346. If you
	experience a high packet error rate, you may slightly increase
	your Fragmentation value within the range of 256-2346. Setting
	the Fragmentation value too low may result in poor performance.
DTIM interval-	(Delivery Traffic Indication Message) 1 is the default setting. A
	DTIM is a countdown informing clients of the next window for
	listening to broadcast and multicast messages.
Authentication-	Select Open system or Shared Key

Open System - The DI-784 will be visible to all devices on the network. This is the default setting

Shared Key - In this mode, in order to access the DI-784 on the network, the device must be listed in the MAC Address Control List

SSID Broadcast-

Super G Mode-

Choose Enabled to broadcast the SSID across the network. All devices on a network must share the same SSID (Service Set Identifier) to establish communication. Choose Disabled if you do not wish to broadcast the SSID over the network.

Super G is a group of performance enhancement features that increase end user application throughput in an 802.11g network. Super G is backwarsd compatible to standard 802.11g devices. For top performance, all wirelss devices on the network should be Super G capable. Select either Disabled, Super G without Turbo, Super G with Dynamic Turbo, or Super G with Static Turbo.

Disabled-

Super G without Turbo-

Super G with Dynamic Turbo-

Super G with Static Turbo-

Standard 802.11g support, no enhanced capabilities.

Capable of Packet Bursting, FastFrames, Compression, and no Turbo mode.

Capable of Packet Bursting, FastFrames, Compression, and Dynamic Turbo. This setting is backwards compatible with non- Turbo (legacy) devices. Dynamic Turbo mode is only enabled when all nodes on the wireless network is Super G with Dy- namic Turbo enabled.

Capable of Packet Bursting, FastFrames, Compression, and Static Turbo. This setting is not backwards compatible with non- Turbo (legacy) devices. Static turbo mode is always on and is only enabled when all nodes on the wireless network is Super G

with Static Turbo enabled. 33