D-Link DCS-5010L user manual Mail, Address e-mails

Section 3 - Configuration

Mail

This section allows you to configure your camera to send snapshots and video clips to an e-mail address. If you are not sure what settings to use, check with your e-mail service provider.

SMTP Server This is the domain name or IP address of your external e-mail server.

Address:

SMTP Server This allows you to set the port for the SMTP Server. The default value

Port: is 25, and should only be changed if advised by your e-mail provider.

Sender e-mailThis is the e-mail address listed as the sender for your notification

Address: e-mails.

Receiver e-mailThis is the e-mail address that your notification e-mails will be sent to.

Address:

User Name: If the SMTP server uses authentication, enter your user name.

Password: If the SMTP server uses authentication, enter your password.

For example, if you want to use Gmail with SSL-TLS for e-mail notifications, you can follow the setup procedure as below:

Step 1 - Enter “smtp.gmail.com” in SMTP Server Address.

Step 2 - Change the SMTP server port number from 25 to 465. Step 3 - Enter your gmail e-mail address in Sender E-mail Address. Step 4 - Enter the destination e-mail address in Receiver E-mail Address.

Step 5 - Enter the user name required to access the SMTP server. Step 6 - Enter the password required to access the SMTP server. Step 7 - Select SSL-TLSand then click Save Settings.

Step 8 - Click the Test button to send a test e-mail to the account listed above.

Note: You can also use STARTTLS, which will use SMTP server port number 587.

Note: If you want to use a Yahoo SMTP server, the SMTP server address will be different between each registered region, and only SMTP port 465 is supported for SSL-TLS.

D-Link DCS-5010L User Manual 31