L2TP/PPTP Clients General parameters
Name – Specifies a name for
the PPTP/L2TP Client.
Username - Specify the
username to use for this
PPTP/L2TP Client.
Password/Confirm
Password - The password to use
for this PPTP/L2TP Client.
Interface IP.- Specifies if the
L2TP/PPTP Client should try to
use a specified IP or get one from
the server.
Remote Gateway - The IP
address of the PPTP/L2TP
Server. To connect to
Dial on demand is used
when the tunnel should only be used when needed, if d iabled the tunnel will always try to be
up.
Authentication protocol
Specify if, and what
authentication protocol to use,
read more about the different
authentication protocols in the
Authentication Protocol
Introduction chapter.
MPPE encryption
If MPPE encryption is going to
be used, this is where the
encryption level is configured.
If L2TP or PPTP over IPSec
is going to be used it has to be
enabled and configured to either
use a Pre-Shared Key or a
Certificate.