VPN between client and an internal network In the following example users can connect to
the main office internal network from anywhere on
the Internet. Communication between the client and
the internal network takes place in an encrypted
VPN tunnel that connects the DFL and the roa ming
users across the Internet.
The example shows a VPN between a roaming
VPN client and the internal network, but you can
also create a VPN tunnel that uses the DMZ network.
The networks at the ends of the VPN tunnel are
selected when you configure the VPN policy.
Follow these steps to add a roaming users tunnel.
Step 1. Go to Firewall and VPN and choose Add new in the IPSec tunnels section.
Step 2. Enter a Name for the new tunnel in the name field. The name can contain
numbers (0-9) and upper and lower case letters (A-Z, a-z), and the special characters -
and _. No other special characters and spaces are allowed.
Step 3. Specify your local network, or your side of the tunnel, for example
192.168.1.0/255.255.255.0, in the Local Net field. This is the network your roaming VPN
clients should be allowed to connect to.
Step 4. Choose authentication type, either PSK (Pre-shared Key) or Certificate-based. If
you choose PSK make sure the clients use exac tly the same PSK.
Step 5. As Tunnel Type choose Roaming User.
Click the Apply button below to apply the change or click Cancel to discard changes.