DI-206 ISDN Remote Router
•Connection Test – Position the cursor over this item and press <Enter> to begin the test. The router will dial the phone number defined above, try to establish a valid link with the answering ISDN device and hang up. This test can only be performed if the Interface is disabled in the Interface Configuration, ISDN submenu.
•Dial Out – Press <Enter> to begin the test. The router will dial the phone number above and negotiate a connection with the answering device. In order for this test to work, a Remote Network Profile must be created for the connection.
•Hang up – Press <Enter> to hang up after Dialing Out.
Ping Test
This test makes sure there is an IP network connection to a particular IP address.
The parameters are described as follows:
•IP Address – This is the IP Address of the device that the router will attempt to reach. The router will check it routing table and try to locate the IP Address.
•Count – The number of pings (packets) that will be sent. A value of 0 will cause pings to be sent continuously.
•Delay (10ms) – The amount of time in 10 millisecond intervals between each ping in the Count.
•Start Ping Test - Press <Enter> or <Return> to begin the test.
Loopback Test
The loopback test is used to test the path ISDN network between your phone company’s switch and the router.
78
