D-Link DI-774 manual TX Rates, Select Open system or Shared Key

Using the Configuration Menu (continued)

Wireless	Advanced > Performance > 802.11g
Performance-

Select 802.11a or 802.11g. 802.11g is selected here. Dis- played in this window are the Wireless Per- formance features for the Access Point por- tion of the DI-774.

TX Rates-

Auto is the default selection. Select from the drop down menu for your selection.

Transmit Power-

Beacon interval-

Full is the default selection. Select from the drop down menu for your selection.

Beacons are packets sent by the DI-774 to synchronize a wire- less network. Specify a value. 100 is the default setting and is recommended.

RTS Threshold-	This value should remain at its default setting of 2346. If incon-
	sistent data flow is a problem, only a minor modification should
	be made.
Fragmentation-	This value should also remain at its default setting of 2346. If you
	experience a high packet error rate, you may slightly increase
	your Fragmentation value within the range of 256-2346. Setting
	the Fragmentation value too low may result in poor performance.
DTIM interval-	(Delivery Traffic Indication Message) 1 is the default setting. A
	DTIM is a countdown informing clients of the next window for
	listening to broadcast and multicast messages.
Authentication-	Select Open system or Shared Key

Open System - The DI-774 will be visible to all devices on the network. This is the default setting

Shared Key - In this mode, in order to access the DI-774 on the network, the device must be listed in the MAC Address Control List

SSID Broadcast- Choose Enabled to broadcast the SSID across the network. All devices on a network must share the same SSID (Service Set Identifier) to establish communication. Choose Disabled if you do not wish to broadcast the SSID over the network.

32