Routing
Dlink DRO-210i User Guide 27
Outbound Interface The network traffic which matches with all the below policy parameters
will be sent out of this interface.
Policy Parameters
Inbound Interface Select the interface through which the incoming traffic will come in.
Source Select the source IP address of the traffic. Select Any when there is no
specific source IP address. However if Specific is selected the
administrator will be allowed to configure specific source IP address for
this policy.
Destination Select the destination IP address of the traffic. Select Any when there is no
specific destination IP address. However if Specific is selected the
administrator will be allowed to configure specific destination IP address
for this policy.
Protocol Select a protocol for the policy.
Source Port Number
(optional)
Enter the Source Port Number to specify the type of application for this
policy. Source port value of zero indicates "Any" Source Port.
Destination Port
Number (optional)
Enter the Destination Port Number to specify the type of application for
this policy. Destination port value of zero indicates "Any" Destination
Port.
After entering all the information press the Apply button. The routes entered will now be
displayed under the Policy Based Routing Table.
Note: Policy Based Routes will be given higher preference over Static/Dynamic routes
to the same destination.