D-Link PM0599-03 owner manual Installation Instructions, Installing the Hanger Bracket

COPYRIGHT © 2006 MERIT INDUSTRIES, INC.

INSTALLATION INSTRUCTIONS

CAUTION

MoD BoX must be solidly fastened to structural mem- bers within the supporting wall.

MoD BoX weighs 130 pounds (50 kg); if it falls, it could cause damage or injury.

CAUTION

Supplied fasteners (1-1/2” lag screws) are for wood wall stud construction. For other types of construc- tion, installer must provide and use appropriate fasteners.

INSTALLING THE HANGER BRACKET

NOTE: It is recommended that all wall installations or removals be performed by two people for safety reasons.

NOTE: Before installing the MoD BoX on a wall, you should first install the hard drive.

1.PREFERRED METHOD*: At the installation location, use a level to mark a horizontal line that is exactly 64-3/8” (163.5 CM) off the floor. This will place the bottom of the MoD BoX at the recommended 38” (965 cm) above the floor. Refer to Figure 1-1.

2.Using the level, mark another horizontal line which is 17" (43.2 cm) below the first line.

3.Locate the wall stud locations on the horizontal lines. Drill 5/32” holes at the marks. Place the hanger against the wall and secure using the (4) 1/4” x 1-1/2” lag screws supplied.

*In order to comply with the height requirements of ADA (Americans with Disabilities Act), this line must be no more than 55-3/8” (140.6 cm) from the floor.

PM0599-03 MOD BOX INSTALLATION & OWNER’S MANUAL 6