Installation Instructions
To determine if the base plate is high enough:
a.Determine the location of the range center line and front panel when the range is in its final position based on the Product Dimensions on page 4 and the actual cabinet/cutout dimensions used for the installation.
b.Determine and mark the required position of the
c.Using a pencil, make a dot next to the notches on both sides of the bracket. Determine if the base plate is as high at the notches by drilling test holes into the wall at both dots with a 1/16” drill bit. Drill just deep enough to see if the bit contacts the base plate. If the bit contacts the base plate the location will support wall installation of the
4.To install the bracket, place it against the wall in the mounting location shown below. Using a drill with 1/8” diameter drill bit, drill four 1 5/8” deep pilot holes perpendicular to the screw seating surfaces shown. Attach the bracket to the wall as shown with the four (4) included #12 x 1 3/4 screws.
#8 x 1”, | #8 x 1 1/4” |
| |
or #12 x 1 3/4 screw, |
| ||
4 places (see text) |
| ||
|
| Front | |
|
| hole | |
Anchor, 4 places: |
| ||
use for concrete |
| ||
| floor only |
| |
| |||
| front hole locations | ||
|
| Range | |
|
| center line | |
Cabinet | 21 3/8” |
| |
(54.3 cm) |
| ||
face below |
| ||
|
| ||
countertop |
|
| |
|
| C | |
|
| L | |
2 3/16” | 10 1/2” | Range front | |
(5.6 cm) | (26.3 cm) | ||
panel | |||
|
| ||
Drywall
bracket 
Notch
Wall
Base plate
#12 x 1 3/4” screw, | Top hole, indicates |
4 places | bracket center line |
Back wall
Range center line
251/4”
(64.1 cm)
Cabinet | to |
| ||||
26 1/4 |
|
| ||||
face below | (66.7 cm) |
| ||||
countertop |
| C | Range front | |||
|
| C |
| |||
|
| L |
|
| L | panel |
|
|
|
|
|
| |
Bracket |
|
| 11 1/2” |
| ||
|
| |||||
center line | (29.2 cm) |
| ||||
9