Installation Instructions

Installing the Range

Peel off the protective layer of plastic that covers the stainless steel surfaces.

Freestanding Installation

1.Measure from the floor to the countertop and adjust the leveling legs as required to position the top frame at the desired height, based on the cabinet and countertop installation.

2.Carefully slide the range into position in the cutout. As you slide the unit into place the rear leg should engage the anti- tip bracket.

3.Using a flashlight look underneath the range and verify that the anti-tip bracket covers the rear leg. See diagram below.

4.Use a level to make sure that the range does not tilt front to back or side to side. Re-adjust the legs to level and change the height if necessary.

Self-Rimming Installation

Installation of the range in the self-rimming configuration is slightly different from freestanding installation since the range top overhangs the countertop cutout.

1.Measure from the floor to the countertop.

2.Adjust the leveling legs to position the bottom edge of the range top trim at countertop height.

3.Carefully slide the range into position in the cutout. As you slide the unit into place the rear leg should engage the anti- tip bracket.

4.Using a flashlight look underneath the range and verify that the anti-tip bracket covers the rear leg. See diagram below.

5.Use a level to make sure that the range does not tilt front to back or side to side. Re-adjust the legs to level and change the height if necessary.

Re-installing the Oven Door

warning

To avoid personal injury or damage to the door from it falling off its hinges:

•Make sure that the notch on the bottom of each hinge rests on top of the lower lip of each hinge receptacle before attempting to open the oven door.

•Rotate the hinge locks toward the front of the range immediately after installation of the door.

1.Grasp the oven door on opposite sides and hold it at a 15° angle from the front of the range. Slide the hinges into the hinge openings, resting the bottom of the hinge arms on the hinge receptacles. Continue to hold the door at a 15° angle with one hand while pushing in on each of the bottom corners of the door. Push until the notch on the bottom of each hinge slips over the lower lip of each hinge receptacle.

2.Lower the door to the fully opened position.

3.Rotate the two hinge locks toward the range.

4.Slowly and carefully open and close the door completely to ensure that it is properly installed.

Anti-tip bracket

Rear leg

16