Installation Instructions

Verifying Proper Operation

1.Remove any packaging from inside the oven.

2.Slide the oven racks onto the supports inside the oven chamber(s) according to the use and care manual.

3.Prior to operating the range, please read the accompanying use and care manual carefully. Important safety, service and warranty information are contained within.

4.Turn on the power supply to the range.

5.Set the clock according to the use and care manual.

6.Press the BAKE key on the control panel. The default bake temperature should appear on the display.

7.Press START. After approximately three (3) minutes, check to make sure the oven is heating.

8.Turn each of the knobs on the front counter-clockwise to the HI position, in turn. Make sure each element begins to heat. On the dual and triple elements, make sure all the elements are working. The residual heat indicator lights for each element should come on when each element is on.

A C

A B

ASingle Circuit Elements

L O H I

Single element ONBDual Circuit Element

L O

H I L O

H I

SINGLE

 

DUAL

Inner element ON

 

Both elements ON
CTriple Circuit Element

H I

L O H I

L O H I

L O

SINGLE

DUAL

 

TRIPLE

Inner element ON Inner and middle All elements ONelements ON

9.If either the oven or cooktop does not operate properly, follow these troubleshooting steps:

◊Verify that power is being supplied to the range.

◊Check the electrical connections to ensure that the installation has been completed correctly.

◊Repeat the above tests.

◊If the appliance still does not work, contact Dacor Distinctive Service at (800) 793-0093, extension 2822. Do not attempt to repair the appliance yourself. If you need service, be sure to have the model and serial numbers available when you call. See the inside cover for location.

Dacor is not responsible for the cost of correcting problems caused by a faulty installation.

Installation Checklist

warning

To ensure a safe and proper installation, the installer must perform the following checklist to ensure that no part of the installation has been overlooked. Proper installation is the responsibility of the homeowner.

1.Has the plastic coating been peeled off of the outside of the range? Have all packaging materials been removed from inside the oven?

2.Are all of the legs extended down to make contact with the floor? Is the unit level? See page 16.

3.Is the range secured in place with the provided anti-tip bracket according to these instructions? See page 8 and 16.

4.Is the range wired and grounded according to these instructions and in accordance with all applicable electrical codes? Has the electrical access cover been replaced? See pages 3 and 10.

5.Is the oven door properly installed according to these instructions? See page 16.

6.Has proper operation been verified?

7.Has the warranty been activated on-line or the warranty card been filled out completely and mailed?

17