OPERATION
CONNECTING THE AC CORD
The outdoor unit is connected to the indoor unit through the AC connecting wire or connection cord. To connect the in- door unit to AC, follow the procedures below:
1.Insert the attached AC plug into a pronged 220V AC outlet.
AC Outlet
and Plug
Plug into 220V AC Outlet.
NOTES:
•Never connect the AC line cord plug to other than the specified voltage (220V).
•Use the attached power cord only.
•The new air conditioner system should be on it’s own 220V circuit. Contact your local electrical installer for in- stallation.
SETTING THE UNIT FOR REMOTE OPERATION
After the unit is fully connected and plugged in, it can be turned on. To turn the unit on and set it for remote operation, follow the procedures below:
1.Open the indoor unit’s cover and make sure the EMERGENCY/REMOTE switch is set to the RE- MOTE position; this will allow the unit to operate with the remote controller.
EMERGENCY/REMOTE Switch
2.Press the ON/OFF button on the remote controller to turn on the unit. The On LED will light on the indoor unit and “ON” will light in the remote display.
To select the various modes and settings, read the following pages.
EMR. REMOCON
THREE MINUTE COMPRESSOR DELAY
•After turning the indoor unit on and setting it for air con- ditioner operation, the compressor (outdoor unit) will not come on for three minutes. This is a feature that will protect the compressor from damage due to quick start and stops.
19
