DS8100A
2
2.7 KEYPAD AND DISPLAY The DS8100A keypad allows entering a menu for selection of one of the following functions:
tware release and operating mode;
Autolearn: starts the procedure making it possible to obtain an automatic, accurate
checking/modifying the relevant parameters;
n within the network (see below);
etting the scanner IP address to be used within the network;
n and features (see below).
by using the Genius™ program (see chapter 3 for
2.7.1 Internal Net Genius™, to assign the
8
allows defining the scanner function (slave/master) within the network and, if configured as
scanner follow the given procedure:
(down arrow) keys for about 2 seconds to
) Use the ▲ (up arrow) or ▼ (down arrow) key to select the “LonWAddrSel”” item, then
press the ENT (enter) key to confirm;
4) Use the ▲ (up arrow) or ▼ (down arrow) key to select your scanner function among
“Master”, “Slave n”, “Slave jolly”, “Disabled”; then, press the ENT (enter) key to confirm;
5) Use the ▲ (up arrow) or ▼ (down arrow) key to select the “Exit” item, then press the ENT
(enter) key to confirm. Repeat this step again to exit the Main Menu and return to the
scanner current operating mode.
Test Mode is particularly advised during the installation phase, since it causes the reader to
be continuously activated allowing to verify its reading features and its reading position with
respect to the barcode.
To enter the Test Mode submenu and configure the scanner follow the given procedure:
) Press and hold both the ▲ (up arrow) and ▼ (down arrow) keys for about 2 seconds to
“Test Mode” item, then press
e reader enters Test Mode.
arrow) key to select the “Exit” item, then press the
e scanner exits the Main Menu and returns to its current
• Welcome: shows the current sof
•
and fast configuration of DS8100A without the necessity of directly
• Internal Net: defines scanner functio
• Ethernet Mode: allows s
• LCD Contrast: sets the LCD contrast ;
• Bus: not used for DS8100A scanners;
Test Mode: allows verifying the scanner reading positio���
The same settings may be performed
details).
This submenu can be used as an alternative to configuration through
S 100A scanner within a master/slave network. D
It
Slave, its address.
o enter the Internal Net submenu and configure theT
1) Press and hold both the ▲ (up arrow) and ▼
enter the Main menu;
2) Use the ▲ (up arrow) or ▼ (down arrow) key to select the “Internal Net” item, then press
the ENT (enter) key to confirm;
3
1
enter the Main menu.
2) Use the ▲ (up arrow) or ▼ (down arrow) key to select the
the ENT (enter) key to confirm. Th
3) Press the ▲ (up arrow) key to exit the Test Mode.
4) Use the ▲ (up arrow) and ▼ (down
ENT (enter) key to confirm. Th
operating mode.
40