DS8100A
3
After defining the parameter val
ader configuration as follows:
ues the following window appears allowing to complete the
- Saving the configuration to disk;
- Switching to Advanced mode;
- Sending the configuration to the scanner.
re
Figure 52 - Genius™ Wizard Closing Window
NOTE
This operating mode is not available when DS8100A works as slave.
Figure 53 - Test Mode Selection
This operating mode causes the reader to be continuously activated allowing to verify its
reading features and its reading position with respect to the barcode. For this reason, it is
particularly advised during the installation phase of the reader.
After 100 scans, the values relative to an internal counter and the decoded code are
displayed and transmitted on the serial interface. The counter reports the percentage of good
reads of the label.
42