ELECTRICAL SAFETY
This product conforms to the applicable requirements contained in the European Standard for
electrical safety EN-60950 at the date of manufacture.
WARNING
This symbol refers to operations that must be performed by qualified
personnel only. Example: opening the device.
WARNING
make sure the power cable is
disconnected to avoid electric shock.
This symbol refers to operations where there is danger of electrical
shock. Before opening the device
LASER SAFETY
The following information is
authorities and refers to the c
provided to comply with the rules imposed by international
orrect use of the DS8100A scanner.
though staring directly at the laser
at the date of manufacture. The reader is classified as a Class 2 laser
here is a safety device which allows the laser to be switched on only if the motor is rotating
bove the threshold for its correct scanning speed.
Standard Regulations
This scanner utilizes up to 4 low-power laser diodes. Al
beam momentarily causes no known biological damage, avoid staring at the beam as one
would with any very strong light source, such as the sun.
Avoid that the laser beam hits the eye of an observer, even through reflective surfaces such
as mirrors, etc.
This product conforms to the applicable requirements of both EN60825-1 and
CDRH 21 CFR1040
product according to EN60825-1 regulations and as a Class II laser product according to
CDRH regulations.
T
a
WARNING
Use of controls or adjustments or performance of procedures other than those
specified herein may result in exposure to hazardous visible laser light.
The laser light is visible to the human eye and is emitted from the window on the side of the
scanner (Figure A).
vi