Datalogic Scanning Matrix-1000 Positioning (Optional)

green

Auto Learn (F2)

Figure 4 – Auto Learn Function

Repeat the procedure if needed, to program different code symbologies, however you must

present only one code at a time to the reader.

Matrix-1000™ is able to decode any code symbology in its library with this procedure.

NOTE

If your application has been configured using Auto Learn, your reader is ready.

If necessary you can use VisiSet™ for advanced reader configuration.

NOTE

Autolearning configuration parameters can be saved to temporary memory

only by selecting the "Autolearning Setup>Store Memory" parameter in

VisiSet™.

The Autolearning function on the keypad button can also be disabled by the

user via VisiSet™.

Positioning (Optional)

At the end of the Auto Learn procedure, you can use the Positioning procedure to center the

code with respect to the reader's FOV.

1. While the desired code is in front of the reader at the correct reading distance, enter the

Positioning function (F1) by pressing and holding the push button until only the F1 LED is

on.

2. Release the button to enter the Positioning function.

Once entered, the reader continuously acquires images and gives visual feedback using

the F1 LED to indicate when the code is centered with respect to the reader's FOV. Slow

blinking means that the positioning value must be improved.

3. To obtain the best value in terms of positioning, move the code and/or the reader so as to

position the code as close as possible to the center of the Field of View, keeping the

correct focus distance. Check F1 LED blinking: the best code positioning corresponds to

fast (almost continuous) blinking.

4. After a short timeout the function automatically exits, the F1 LED remains on continuously

and then stops blinking.

If no valid code is present in the FOV, after about 3 minutes, Matrix-1000™ will automatically

exit, the F1 LED will not remain on continuously but it will just stop blinking.

To cancel the Positioning function, press and hold the keypad button at any time during the

procedure: the F1 LED will stop blinking.