|
| INSTALLATION | ||
3. | Assembly of the 10” Transition. |
|
|
|
| The transition supplied with the hood mounts to the top |
|
|
|
| of the hood, Figure 5. |
|
| Duct |
|
|
|
| |
| a. Place the transition piece over the hood exhaust |
|
| Transition |
|
|
|
| |
| and secure with 4 screws provided. |
|
|
|
| b. Duct tape connection between transition and |
|
|
|
| hood. |
| f | |
| o | |||
| To |
|
| |
|
| p |
| d |
|
|
| o | |
|
| o |
| |
| c. Remove tape holding damper. | H |
|
|
|
|
|
| |
4. | Check that the screws on bottom of chimney structure |
|
|
|
| are partially screwed into place; these will serve to hang | FIG.5 |
|
|
| and fix the canopy. |
|
|
|
5. | If already mounted in place remove all grease filters. |
|
|
|
6. | Back out the hanging screws on the bottom of the |
|
|
|
| chimney structure to 1/4” gap. |
|
|
|
| Lift the canopy up to the chimney support . |
|
|
|
| Carefully align the canopy keyhole to the screws on the |
|
|
|
| chimney support. |
|
|
|
| Slide the hood to engage the keyhole slots. See Fig. 6. |
|
|
|
7. | Tighten screws securely (from inside the canopy). Fix | FIG.6 |
|
|
|
|
| ||
| canopy to structure with 4 screws from inside the |
|
|
|
| canopy. See Fig. 7. |
|
|
|
8. | Make final angular adjustment to unit at ceiling if necessary, then finish installation adding two | |||
| fixing screws. See Fig. 8. |
|
|
|
Screw |
FIG.7 |
additional |
fixing screw |
FIG.8 |
10