dCS 904 User Manual

Manual for Software Version 1.5x and 1.36

dCS Ltd

June 2000

 

 

TROUBLESHOOTING

Error Codes and Messages

The error codes reported by dCS 904 provide an effective means to diagnose the majority of problems that may be encountered in use - including problems with the overall system the unit operates in, internal device warnings and internal device failures. Please note that through damage or component failure, the unit self check may fail to operate. If this happens, please contact your distributor or dCS for assistance.

Internal Device Error Codes

Sometimes the unit may misbehave. If there is an internal reason, an internal device error code may be displayed as follows:

Err.xy

an error xy (see table below) has been detected

where xy values have the following meanings:

 

 

Code

Description

01

 

E2 memory (EEPROM) not present

02

Error initialising DSP

03

Error loading DSP

04

Error initialising DSP for coefficients

05

Error initialising DSP for coefficients

06

Error loading DSP coefficients

07

Error loading DSP coefficients

08

Error sending command

09

Error sending command

10

Error sending command

11

Error sending command

12

Error with LSB/MSB configuration

13

Error with LSB/MSB configuration

14

Error with LSB/MSB configuration

15

Error configuring FPGA

99

DSP error

Table 13 - Internal Error Codes

If you get any of these, please contact dCS, with as much information as possible to help us re-create the problem. Some of these may have hardware problems as their cause, some may have software.

Manual part no: DOC135904 iss 2B2

Page 74

135904ma2b2.pdf file available from website

Contact dCS on + 44 1799 531 999

email to: more@dcsltd.co.uk

(inside the UK replace + 44 with 0)

web site: www.dcsltd.co.uk