Dell 1090 manual Removing the Display Assembly

Back to Contents Page

Display

Dell™ Inspiron™ 1090 Service Manual

Display Assembly

Hinge Caps

Display Bezel

Display Hinges

Display Panel

Display Cable

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty.

CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on your computer).

CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the computer.

Display Assembly

Removing the Display Assembly

1.Follow the instructions in Before You Begin.

2.Remove the label door (see Removing the Label Door).

3.Remove the keyboard (see Removing the Keyboard).

4.Remove the palm-rest assembly (see Removing the Palm-Rest Assembly).

5.Remove the battery (see Removing the Battery).

6.Remove the memory module (see Removing the Memory Module).

7.Disconnect the antenna cables from the Mini-Card(s).

8.Disconnect the ambient light-sensor cable, touch-screen cable, display cable, and camera cable from their connectors on the system board.

9.Note the routing of the ambient light-sensor cable, touch-screen cable, display cable, and camera cable and remove these cables from the routing guides.

10.Note the routing of the Mini-Card antenna cables and remove the cables from the routing guides.