Using the On-Screen Display OSD Menu, Exit, Contrast

C		Use this button for direct access to the "Brightness" and "Contrast" control menu.
	Brightness/Contrast
	Hot Key

C		Use these buttons to navigate and adjust the slider-bar (decrease/increase ranges) controls in the OSD.
and
D	Down (-) and Up
	Down (-) and Up
	(+)
D		Use this button to activate automatic setup and adjust menu. The following dialog appears on a black screen as the
		monitor self-adjusts to the current input:
	Auto Adjust
		Auto Adjustment allows the monitor to self-adjust to the incoming video signal. After using Auto Adjustment, you can
		further tune your monitor by using the Pixel Clock (Coarse) and Phase (Fine) controls under DISPLAY SETTINGS.
		NOTE: Auto Adjust does not occur if you press the button while there are no active video input signals or attached
		cables.
E		Use the Power button to turn the monitor on and off.
		The green LED indicates the monitor is on and fully functional. An amber LED indicates DPMS power save mode.
	Power button
	(with power light
	indicator)

Using the On-Screen Display (OSD) Menu

Accessing the Menu System

NOTE: If you change the settings and then either proceed to another menu or exit the OSD menu, the monitor automatically saves those changes. The changes are also saved if you change the settings and then wait for the OSD menu to disappear.

1.Push the MENU button to launch the OSD menu and display the main menu.

Main Menu for Analog (VGA) Input

Main Menu for non Analog (non VGA) Input

NOTE: AUTO ADJUST is only available when you are using the analog (VGA) connector.

2.Push the and buttons to move between the setting options. As you move from one icon to another, the option name is highlighted. See the following table for a complete list of all the options available for the monitor.