Dell 4100 Microprocessor Module, Removing the Microprocessor Module, Preparing to Work Inside the Computer

Removing and Replacing Parts: Dell Inspiron 4100

2. Tighten the four captive screws, labeled 1 through 4, in consecutive order.

Microprocessor Module

Removing the Microprocessor Module

NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries.

NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.

NOTICE: Read "Preparing to Work Inside the Computer" before performing the following procedure.

NOTICE: Do not touch the processor die. Press and hold the microprocessor down on the substrate on which the die is mounted while turning the cam screw to prevent intermittent contact between the cam screw and microprocessor.

NOTICE: To avoid damage to the microprocessor, hold the screwdriver so that it is perpendicular to the microprocessor when turning the cam screw.

file:///I/SERVICE%20MANUALS/DELL%20MANUALS/LA...20ok/Inspiron/4100/4100_SERVICE_MAN/remove.htm (38 of 52)6/21/2004 1:02:31 AM