![EU Compliance](/images/new-backgrounds/143187/143187119x1.webp)
The user’s manual for end users must include the following information in a prominent location "IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be
EU Compliance
Regulatory compliance of the DELL5002
The DELL5002 are made for OEM integrations only. The European regulations applying to the DELL5002 is the R&TTE Directive 1999/5/EC.
DELL5002 meets the following requirements of the R&TTE Directive.
R&TTE Directive article | Test category | Harmonized standard |
|
|
|
Article 3.1(a) | Protection of health and | EN |
| safety |
|
|
|
|
Article 3.1(b) | EMC | EN 301 |
|
|
|
Article 3.2 | Effective use of the | EN 300 328 |
| spectrum |
|
|
|
|
The conformity assessment for the DELL5002 were completed in accordance with the R&TTE Directive Annex IV procedures, and the EC Declaration of Conformity is attached to this manual.
Cautions regarding regulatory compliance when integrating the DELL5002
The person integrating the DELL5002 becomes the manufacturer of the final product and is therefore responsible for demonstrating compliance of the product with the essential requirements of the R&TTE Directive.
In all cases assessment of the final product must be made against the Essential requirements of the R&TTE Directive Article 3.1(a) and (b), safety and EMC respectively, and any relevant Article 3.3 requirements
This device is intended only for OEM integrators under the following conditions:
1This appliance and its antenna must not be
58
Appendix I. Regulatory statement