Updates Interval (5-32768) — Indicates that rate at which LLDP advertisement updates are sent. The possible field range is 5 - 32768 seconds. The default value is 30 seconds.
Hold Time (2-10) — Indicates the amount of time that LLDP packets are held before the packets are dis- carded. The possible field range is 2 - 10 seconds. The field default is 4 seconds.
Reinitializing Delay (1-10)— Indicates the amount of time that passes between disabling LLDP and when reinitializing begins. The possible field range is 1 - 10 seconds. The field default is 2 seconds.
Transmit Delay (1-8192)— Indicates the amount of time that passes between successive LLDP frame trans- missions due to changes in the LLDP local systems MIB. The possible field value is
1 – 8192 seconds. The field default is 2 seconds.
Configuring LLDP Using CLI Commands
Table 1-1. LLDP Properties CLI Commands
CLI Command | Description |
| |
lldp enable (global) | Enables enable Link Layer Discovery |
| Protocol. |
lldp hold-multiplier number | Specifies the time that the receiving |
| device should hold a Link Layer |
| Discovery Protocol (LLDP) packet |
| before discarding it. |
lldp reinit-delay Seconds | Specifies the minimum time an LLDP |
| port will wait before reinitializing. |
lldp tx-delay Seconds | Specifies the delay between successive |
| LLDP frame tr.ansmissions. |
| |
The following is an example of the CLI commands:
Console(config)# interface ethernet g5
Console(config-if)# lldp enable
