PowerConnect 6224/6224F/6224P/6248/6248P Release Notes
System Firmware Version 3.2.0.6 Page 27
Summary User Impact Workaround
ISDP updates are not
including Voice VLAN
Reply TLV when
Voice VLAN ID on
interface is changed.
Upon changing configuration immediately
after getting the VLAN assigned, DUT stops
advertising Voice VLAN reply TLV in its
ISDP updates which causes IP phone to
change its VLAN properties.
The administrator can work around this
problem by shutting down the port and
restarting it after the configuration is
changed.
PC6200 fails to re-
authorize IP phone
upon enabling and
disabling Voice VLAN
authentication.
Once a phone is configured, enable Voice
VLAN authentication, wait for DHCP
discovery again, and then disable Voice
VLAN authorization. On disabling Voice
VLAN authorization, PC6200 fails to
authorize IP phone based on the received
LLDP packet (with network policy TLV).
Disconnect and reconnect the phone to the
port, the phone gets authorized.
When Line or enable
method is used as
login method and
enable authentication
is none, the user is
unable to enter into
Privileged EXEC
mode.
If login authentication method is Line or
Enable, and enable authentication is None,
you will always get read-only access
(because there is no user configured for line
or enable authentication). The user will
never get read-write access.
If enable authorization is set to None, ensure
that the login authorization method is at least
TACACS, Radius, or Local. Any
authentication method that requires a user
configuration will ensure that the user will get
proper access based on how the user is
configured.
Cannot change LAG
mode from Static to
Dynamic via CLI.
Cannot change LAG mode from Static to
Dynamic via CLI. The user may change the LACP Mode using
the Graphical User Interface.