Dell 6224F, 6248P, 6224P specifications Port Configuration Show Command, Custom Protocol Based VLANs

Title	Description
show ip ospf neighbor	This command has been enhanced to list the per neighbor graceful restart
	status described in the RFC 4750 MIB. Possible values for Restart Helper
	Status are as follows:
	• Helping – This router is acting as a helpful neighbor to this neighbor.
	• Not Helping – This router is not a helpful neighbor at this time.

Port Configuration Show Command

Title	Description
show interfaces detail {ethernet interface port-	A new single command that shows VLAN, STP, Port status, and Port
channel port-channel-number}	Configuration information.
	Default: Not applicable

Custom Protocol Based VLANs

Title	Description
vlan protocol group add protocol <groupid>	Previously only ARP, IP and IPX are configurable as protocols for
ethertype <value>	protocol-based VLANs. This has been extended so that any Ethertype
no vlan protocol group add protocol <groupid>	may be used.
	• groupid—The protocol-based VLAN group ID, which is
ethertype <value>	automatically generated when you create a protocol-based VLAN
	group with the vlan protocol group command. To see the group
	ID associated with the name of a protocol group, use the show
	port protocol all command.
	• ethertype—The protocol you want to add. The ethertype can be
	any valid hexadecimal number in the range 1536 to 65535.
	Default: Not applicable
vlan protocol group <groupid>	If the user creates multiple vlan protocol groups, deletes one of them, and
	then saves the configuration, the older implementation of this command
no vlan protocol group <groupid>	resulted incorrectly applying the groupids on reload. Hence, the existing
	command vlan protocol group <groupname> is updated to vlan
	protocol group <groupid> so that groupid is used for both configuration
	and script generation.
	• groupid—The protocol-based VLAN group ID, to create a protocol-
	based VLAN group. To see the created protocol groups, use the
	show port protocol all command.
	Default: Not applicable
vlan protocol group name <groupid>	This is a new command for assigning a group name to vlan protocol group
<groupName>	id.
no vlan protocol group name <groupid>	• groupid—The protocol-based VLAN group ID, which is
	automatically generated when you create a protocol-based VLAN
	group with the vlan protocol group command. To see the group
	ID associated with the name of a protocol group, use the show
	port protocol all command
	• groupName—The group name you want to add. The group name
	can be up to 16 characters length. It can be any valid alpha
	numeric characters.
	Default: Not applicable

VLAN Name Support with RADIUS Server

Title	Description
show dot1x Ethernet interface	The command was updated to display the VLAN Id, or name as required.
	Default: Not applicable

22 System Firmware Version 3.2.0.6