Dell 7000 manual 7RXFK3DG$VVHPEO

7RXFK￿3DG￿$VVHPEO\

This section provides the removal procedure for the touch pad assembly.

	touch pad
	touch pad bracket
touch pad	4-mm screws (4)
button board
	touch pad
	flex cable
4-mm	ZIF connector
screws (3)

)LJXUH￿￿￿￿￿￿￿￿7RXFK￿3DG￿$VVHPEO\￿5HPRYDO

This procedure assumes that you have removed the palmrest assembly from the base assembly and that you have removed the hard-disk drive heat shield. To remove the touch pad assembly, follow these steps (see Figure 4-33):

1.Remove the three 4-mm screws securing the touch pad button board.

2.Disconnect the two speaker cables from connectors JP5 and JP3 on the touch pad button board.

3.Disconnect the speaker wire harness from connector JP1 on the touch pad button board.

4.Disconnect the touch pad flex cable from ZIF connector JP4 on the touch pad button board. Use the pick to pry up the latches on each side of the connector.

&$87,21￿￿/LIW￿DZD\￿WKH￿FDEOH￿RQO\￿DIWHU￿WKH￿=,)￿FRQQHFWRU￿LV￿ RSHQHG￿￿VHH￿´=,)￿&RQQHFWRUVµ￿IRXQG￿HDUOLHU￿LQ￿WKLV￿FKDSWHU￿￿￿3XOO￿

LQJ￿WKH￿FDEOH￿IURP￿WKH￿FRQQHFWRU￿GDPDJHV￿WKH￿FRQGXFWLYH￿FRDWLQJ￿ RQ￿WKH￿HQG￿RI￿WKH￿FDEOH￿

5.Disconnect the touch pad flex cable from ZIF connector J1 on the touch pad. Use the pick to pry up the brown center piece on the connector.

4-50'HOO￿,QVSLURQ￿￿￿￿￿￿6HUYLFH￿0DQXDO