Dell 7000 manual +LQJH6DGGOHV

+LQJH￿6DGGOHV

This section provides the removal procedure for the hinge saddles.

DG GOH

left hinge saddle

plastic frame

6-mm screw (1)

4-mm screws (4) 4-mm screws (4)

10-mm screws (2)

20-mm screws (2)

right hinge saddle

LED cable

)LJXUH￿￿￿￿￿￿￿￿+LQJH￿6DGGOH￿5HPRYDO

This procedure assumes that you have removed the PC Card heat sink and LVDS board. To remove the hinge saddles, follow these steps (see Figure 4-40):

1.Remove the four 4-mm screws from the top of the left and right hinge saddles.

2.Remove the four 4-mm screws from the back of the computer above the ports.

3.Remove the 10-mm screw and 20-mm screw from the right hinge saddle and remove the saddle.

4.Remove the 10-mm screw and 20-mm screw from the left hinge saddle and remove the saddle.

5.Disconnect the LED cable from connector J6 on the system board.

6.Remove the 6-mm screw from the plastic frame, remove any tape, and remove the plastic frame.

4-60'HOO￿,QVSLURQ￿￿￿￿￿￿6HUYLFH￿0DQXDO