Dell 7000 manual 6SHDNHUV

6SHDNHUV

This section provides the removal procedure for the speakers.

￿

display latch

speaker wire harness

speakers (2)

left speaker	display latch
	spring
cover
	right speaker
	cover

4-mm	speaker
	cables (2)
screws (5)

)LJXUH￿￿￿￿￿￿￿￿6SHDNHU￿5HPRYDO

This procedure assumes that you have removed the palmrest assembly from the base assembly and that you have removed the hard-disk drive heat shield and touch pad assembly. To remove the speakers, follow these steps (see Figure 4-34):

1.Remove any tape securing the speaker cables.

2.Remove the three 4-mm screws securing the left speaker cover.

NOTE: Before removing the speaker cables and wire harness, be sure to note their routing through the slots and pins so you can correctly reinstall the components.

3.Remove the left speaker cover, speaker, and speaker cable.

4.Remove the speaker wire harness.

5.Remove the two 4-mm screws securing the right speaker cover.

6.Remove the right speaker cover, speaker, and speaker cable.

The display latch is no longer secured by the speaker covers. Be careful not to lose the spring.

7.Remove the display latch and spring.

To replace the speaker, resolder the speaker cable to the new speaker.

When reinstalling the speakers, be especially careful to route the speaker cables and speaker wire harness through the appropriate slots and pins.

4-52'HOO￿,QVSLURQ￿￿￿￿￿￿6HUYLFH￿0DQXDO