Dell 760 Small Form Factor

Back to Contents Page
 Small Form Factor
Dell™OptiPlex™760ServiceManual
Removing the Computer Cover
Inside Your Computer
System Board Components
Removing the Computer Cover



1. Follow the procedures in Working on Your Computer.

2. If you have installed a padlock through the padlock ring on the back panel, remove the padlock.

3. Slide the release latch back as you lift the cover.

4. Pivot the cover up using the bottom hinges as leverage points.

5. Remove the cover from the hinge tabs and set it aside on a soft nonabrasive surface.

Inside Your Computer



WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the computer cover.
1
security cable slot
2
cover release latch
3
padlock ring
4
computer cover
WARNING: Graphics card heat sinks can become very hot during normal operation. Ensure that a graphics card heat sink has had sufficient time
to cool before you touch it.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING: To avoid electrical shock, always unplug your computer from the electrical outlet before removing the computer cover.