Dell 760 - page 21


8. Insert the card firmly into the card connector on the riser-card cage.

9. Lower the card-retention latch and press it into place, securing the card(s) in the computer.

10. Replace the riser-card cage:
a. Align the tabs in the side of the riser-card cage with the slots on the side of the computer, and slide the riser-card cage down into place.
b. Ensure that the riser cards are fully seated in the connectors on the system board.

11. Reconnect any cables that you removed in step 4.

12. Connect any cables that should be attached to the card.


13. Replace the computer cover (see Replacing the Computer Cover), reconnect the computer and devices to electrical outlets, and then turn them on.

14. If you installed a sound card:
a. Enter system setup, select System Configuration® Miscellaneous Devices, and change the Audio setting to Disabled (see Entering System
Setup).
1
release tab
2
card-retention latch
3
card
4
card-edge connector
5
card connector


1
riser-card cage
2
slots
3
riser cards
4
system board connectors
CAUTION: Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer cover from closing properly
or cause damage to the equipment.