Dell P08E001, 7HR9P, N7010, P08E series setup guide Using Support Tools

Alert! Previous attempts at booting this system have failed at checkpoint [nnnn]. For help

in resolving this problem, please note this checkpoint and contact Dell Technical Support — The computer failed to complete the boot routine three consecutive times for the same error. Contact Dell (see “Contacting Dell” on page 72).

CMOS checksum error — Possible system board failure or Real Time Clock (RTC) battery low. Replace the coin-cell battery (see the Service Manual at support.dell.com/manuals) or contact Dell (see “Contacting Dell” on page 72).

Hard-disk drive failure — Possible hard drive failure during POST. Contact Dell (see “Contacting Dell” on page 72).

Keyboard failure — Keyboard failure or loose cable.

To replace the keyboard, see the Service Manual at support.dell.com/manuals.

Using Support Tools

No boot device available — No bootable partition on hard drive, the hard drive cable is loose, or no bootable device exists.

•If the hard drive is your boot device, ensure that the cables are connected and that the drive is installed properly and partitioned as a boot device.

•Enter system setup and ensure that the boot sequence information is correct (see the Dell Technology Guide available on your hard drive or at support.dell.com/manuals).

CAUTION - Hard Drive SELF MONITORING SYSTEM has reported that a parameter has exceeded its normal operating range. Dell recommends that you back up your data regularly. A parameter out of range may or may not indicate a potential hard drive problem — S.M.A.R.T error, possible hard drive failure. Contact Dell (see “Contacting Dell” on page 72).

53