108 Removing and Installing Parts
6
Gently slide the drive into place until you feel a click or feel the drive securely installed.
7
Connect the power and hard drive cables to the drive.
8
Check all connectors to be certain that they are properly cabled and firmly seated.
9
Replace the computer cover ("Replacing the Computer Cover" on page 119).
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
10
Connect your computer and devices to electrical outlets, and then turn them on.
See the documentation that came with the drive for instructions on installing any software required for
drive operation.
Floppy Drive CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the Product
Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before
opening the cover.
NOTE: If you are adding a floppy drive, see "Installing a Floppy Drive" on page110.
Removing a Floppy Drive
1
Follow the procedures in "Before You Begin" on page 77.
2
Remove the computer cover (see "Removing the Computer Cover" on page 78).
3
Disconnect the power and floppy drive cables from the back of the floppy drive.
4
Disconnect the other end of the floppy drive cable from the system board.