Dell 9200 owner manual Clearing Cmos Settings, 133

4Connect your computer and monitor to electrical outlets, and then turn them on.

5After the Microsoft® Windows® desktop appears on your computer, shut down the computer (see "Turning Off Your Computer" on page 77).

6Turn off the monitor and disconnect it from the electrical outlet.

7Disconnect the computer power cable from the electrical outlet, then press the power button to ground the system board.

8Remove the computer cover (see "Removing the Computer Cover" on page 78).

9Locate the 2-pin password jumper (CLRPSWD) on the system board (see "System Board Components" on page 81) and attach the jumper to pins 1 and 2 to reenable the password feature.

10Replace the computer cover (see "Replacing the Computer Cover" on page 119).

NOTICE: To connect a network cable, first plug the cable into the network device and then plug it into the computer.

11Connect your computer and devices to electrical outlets, and then turn them on.

Clearing CMOS Settings

CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.

1Follow the procedures in "Before You Begin" on page 77.

2Reset the current CMOS settings:

a Locate the 2-pin CMOS jumper (CLRCMOS) on the system board (see "System Board Components" on page 81).

NOTE: When you receive your computer, there is no jumper plug on the CMOS jumper.

bRemove the jumper plug from the password jumper (CLRPSWD) pins 1 and 2.

cPlace the jumper plug on the CMOS jumper (CLRCMOS) pins 1 and 2 and wait approximately five seconds.

dRemove the jumper plug and replace it on the password jumper (CLRPSWD) pins 1 and 2.

3Replace the computer cover (see "Replacing the Computer Cover" on page 119).

NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.

4Connect your computer and devices to electrical outlets, and then turn them on.

Appendix

133